Harwin Z80-280 Manuale Utente Scaricare il pdf (Pagina 2)

IS-25 Issue: 4 Date: 19.06.12 C/Note: 11759 Page 2 of 3

7. Repeat steps 4 to 6 until the moulding is populated as required. Care should be taken not to

damage any contacts. It is recommended that the moulding be supported by a small fixture

or a hard flat surface. Do not support the mould on any latches fitted, or pressure exerted on

inserting the contacts will bend the latches.

Figure 1

Figure 2 Figure 3

(Correct contact position (Incorrect contact position

- -

Note: Female contact shown

Insertion Tool

Partially

Inserted

Contact

Moulding

(back face)

Cable

Groove

Cable

Contact

Moulding

Contact

Moulding

1 2 3

Nessun commento

Harwin Z80-280 Manuale Utente Pagina 2